Ip Igmp Query-Max-Resp-Time - Dell S6100 Configuration Manual

Usage Information If you have configured the hello interval value to be greater than 18000, you must first reset that value to be less
than or equal to 18000 before upload. Otherwise, the command execution fails during bootup and the hello interval
value is set to the default value.

ip igmp query-max-resp-time

Set the maximum query response time advertised in general queries.
NOTE: The IGMP query-max-resp-time value must be less than the IGMP query-interval value.
Syntax ip igmp query-max-resp-time seconds
To return to the default values, use the no ip igmp query-max-resp-time command.
Parameters
seconds
Defaults 10 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.0)
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
7.6.1.0
7.5.1.0
E-Series legacy
command.
644 Internet Group Management Protocol (IGMP)
Enter the number of seconds for the maximum response time. The range is from 1 to 25.
The default is 10 seconds.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the S-Series in Interface VLAN mode only to enable the system to act as
an IGMP Proxy Querier.
Introduced on the C-Series in Interface VLAN mode only to enable the system to act as
an IGMP Proxy Querier.