Dot1X Mac-Auth-Bypass - Dell S6100 Configuration Manual

Dell(conf-dot1x-profile)#show config
dot1x profile mySupplicants
mac 00:50:56:aa:01:10
mac 00:50:56:aa:01:11
Dell(conf-dot1x-profile)#
Dell(conf-dot1x-profile)#exit

dot1x mac-auth-bypass

Enable MAC authentication bypass. If 802.1X times out because the host did not respond to the Identity Request frame, Dell Networking
OS attempts to authenticate the host based on its MAC address.
Syntax dot1x mac-auth-bypass
To disable MAC authentication bypass on a port, use the no dot1x mac-auth-bypass command.
Defaults Disabled
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
9.0.0.0
8.3.19.0
8.3.12.0
8.3.11.1
8.4.1.0
Usage Information To disable MAC authentication bypass on a port, enter the no dot1x mac-auth-bypass command.
dot1x max-eap-req
Configure the maximum number of times an extensive authentication protocol (EAP) request is transmitted before the session times out.
Syntax dot1x max-eap-req number
To return to the default, use the no dot1x max-eap-req command.
164 802.1X
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the C-Series and S-Series.