Clear Ipv6 Route - Dell S6100 Configuration Manual

Version
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.3(0.1)
Usage Information You can partition the LPM table to store IPv6 prefixes greater than /64 mask length. Requires reboot of the switch
to take effect as the SDK handles this only during its initialization.

clear ipv6 route

Clear (refresh) all or a specific route from the IPv6 routing table.
Syntax clear ipv6 route [vrf vrf-name] {* | ipv6-address prefix-length}
Parameters
vrf vrf-name
*
ipv6-address prefix-
length
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.0.0
8.3.19.0
8.3.7.0
8.2.1.0
7.8.1.0
7.4.1.0
814 IPv6 Basics
Description
Introduced on the S3048–ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
(Optional) Enter the keyword vrf followed by the name of the VRF to clear the IPv6
routes corresponding to that VRF.
Enter the * to clear (refresh) all routes from the IPv6 routing table.
Enter the IPv6 address in the x:x:x:x::x format then the prefix length in the /x format. The
range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
Description
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Added support for VRF.
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.