Arp Inspection-Trust - Dell S6100 Configuration Manual

arp inspection-trust

Specify a port as trusted so that ARP frames are not validated against the binding table.
Syntax arp inspection-trust
Defaults Disabled
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
8.2.1.0
Related Commands
•
clear ip dhcp snooping
Clear the DHCP binding table.
Syntax clear ip dhcp snooping {binding | source-address-validation discard-counters
[interface interface]}
Parameters
binding
558 Dynamic Host Configuration Protocol (DHCP)
INTERFACE
INTERFACE PORT-CHANNEL
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the C-Series and S-Series.
arp inspection — enable dynamic ARP inspection on a VLAN.
Clears the binding table.