Hardware Forwarding-Table Mode - Dell S6100 Configuration Manual

• Save the changes and reboot the system for UFT mode profiling to take effect.

hardware forwarding-table mode

Select a mode to initialize the maximum scalability size for L2 MAC table or L3 Host table or L3 Route table.
Syntax hardware forwarding-table-mode {scaled-l2-switch | scaled-l3-hosts | scaled-l3-
routes}
Parameters
scaled-l2-
switch
scaled-l3–
hosts
scaled-l3–
routes
Defaults UFT mode 2
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.7(0.0)
Usage Information This command takes effect only after reboot.
Related Commands show hardware forwarding-table mode
the next boot.
show hardware forwarding-table mode
Display the hardware forwarding table mode in the current boot and in the next boot.
Syntax show hardware forwarding-table mode
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Enter the keywords scaled-l2-switch to select the forwarding table mode for
scaling l3 switch entries.
Enter the keywords scaled-l3–hosts to select the forwarding table mode for scaling
l3 host entries.
Enter the keywords scaled-l3–routes to select the forwarding table mode for
scaling l3 route entries.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S6000, S6000-ON, and Z9500 switch..
— displays the hardware forwarding table mode in the current boot and in
Content Addressable Memory (CAM) 461