Dell S6100 Configuration Manual page 897

Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.11.1
Usage Information
Use this command to confirm that the neighbor adjacencies are operating correctly. If you suspect that they are
not, you can verify the specified area addresses of the routers by using the show isis neighbors command.
The following describes the show isis neighbors command shown in the following example.
Field
System Id
Interface
State
Type
Priority
Uptime
Circuit Id
Example
The bold sections below identify that Multi-Topology IS-IS is enabled. This command displays only one IP address
per line.
Dell# show isis neighbors
System Id Interface State Type Priority Uptime Circuit Id
TEST Te 1/1/7/1 Up L1L2(M) 127 09:28:01 TEST.02
!
Dell#show isis neighbors detail
System Id Interface State Type Priority Uptime Circuit Id
TEST Te 1/1/7/1 Up L1L2(M) 127 09:28:04 TEST.02 Area Address(es):
49.0000.0001
IP Address(es): 25.1.1.3*
MAC Address: 0000.0000.0000
Hold Time: 28
Link Local Address: fe80::201:e8ff:fe00:492c
Topology: IPv4 IPv6 , Common (IPv4 IPv6 )
Adjacency being used for MTs: IPv4 IPv6
Dell#
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Added support for VRF. Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Description
The value that identifies a system in an area.
The interface, slot, and port in which the router was discovered.
The value providing status about the adjacency state. The range is Up and Init.
This value displays the adjacency type (Layer 2, Layer 2 or both).
IS-IS priority the neighbor advertises. The neighbor with highest priority becomes the
designated router for the interface.
Displays the interfaces uptime.
The neighbor's interpretation of the designated router for the interface.
Intermediate System to Intermediate System (IS-IS) 897