Exec Privilege; Os Command Line Reference Guide; Description; Introduced On The S6100-On - Dell S6100 Configuration Manual

iscsi target port

Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication is monitored.
Syntax iscsi target port [tcp-port-2...tcp-port-16]ip-address [ip-address]
To remove the configured iSCSI target ports or IP addresses, use the no iscsi target port command.
Parameters
tcp-
port-2...tcpport- 16
ip-address
(Optional)
Defaults 860, 3260
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking

OS Command Line Reference Guide.

Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
8.3.19.0
8.3.12.0
8.3.16.0
Usage Information
You can configure up to 16 target TCP ports on the switch in one command or multiple commands.
When you use the no iscsi target port command and the TCP port you wish to delete is one bound to a
specific IP address, the IP address value must be included in the command.
show iscsi
Display the currently configured iSCSI settings.
Syntax show iscsi
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Enter the tcp-port number of the iSCSI target ports. The tcp-port-n is the TCP port
number or a list of TCP port numbers on which the iSCSI target listens to requests.
Separate port numbers with a comma. The default is 860, 3260.
Enter the ip-address that the iSCSI monitors. The ip-address specifies the IP address of
the iSCSI target.

Description

Introduced on the S6100–ON.
Introduced on the Z9100–ON.

Introduced on the S4048-ON.

Introduced on the S4820T.
Introduced on the S4810.
Introduced on MXL 10/40GbE Switch IO Module.
EXEC

EXEC Privilege

iSCSI Optimization 907