Dell S6100 Configuration Manual page 792

longer-prefixes
summary
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.4(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
7.6.1.0
Usage Information The following describes the show ip fib stack-unit command shown in the following example.
Field
Destination
Gateway
First-Hop
Mac-Addr
Port
VId
EC
If weighted ECMP is enabled, then the show ip fib stack-unit command display a new column named W-
EC (Weighted ECMP). This column displays either a value of 1 or 0 depending on whether or not a route is
assigned with a weight.
Example
Dell# show ip fib stack-unit 1
Destination
-------------------------------------------------------------------------------------------
1.1.1.2/32
792 IPv4 Routing
(OPTIONAL) Enter the keywords longer-prefixes to view all routes with a common
prefix.
(OPTIONAL) Enter the keyword summary to view the total number of prefixes in the FIB.
EXEC
EXEC Privilege
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Added support for VRF.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for up to seven stack members.
Introduced on the S-Series.
Description
Lists the destination IP address.
Displays either the word "direct" and an interface for a directly connected route or the
remote IP address used to forward the traffic.
Displays the first hop IP address.
Displays the MAC address.
Displays the egress-port information.
Displays the VLAN ID. If no VLAN is assigned, zero (0) is listed.
Displays the number of ECMP paths.
Gateway
via 1.1.1.2, Vl 1000
First-Hop Mac-Addr Port
1.1.1.2 00:01:00:00:00:02 Te 1/1/1/1 1000
VId EC
0