Show Arp - Dell S6100 Configuration Manual
Hide thumbs
Also See for S6100:
- Configuration manual (1081 pages) ,
- Installation manual (54 pages) ,
- Release notes (13 pages)
Table of Contents
Advertisement
Version
8.3.19.0
8.3.11.1
8.1.1.0
7.5.1.0
pre-6.1.1.0
Usage Information
When a static route (or a protocol route) overlaps with Management static route, the static route (or a protocol
route) is preferred over the Management Static route. Also, Management static routes and the Management
Connected prefix are not reflected in the hardware routing tables. Separate routing tables are maintained for IPv4
and IPv6 management routes. This command manages both tables.
Related Commands
•
•
show arp
Display the ARP table.
Syntax
show arp [vrf vrf-name] [interface interface | ip ip-address [mask] |
macaddress mac-address [mac-address mask]] [retries] [static | dynamic]
[inspection {database | statistics][summary]
Parameters
vrf vrf-name
interface interface
784
IPv4 Routing
Description
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the C-Series.
Introduced on the E-Series.
interface ManagementEthernet
Standby RPM).
speed (Management interface)
(OPTIONAL) Enter the keyword vrf and then the name of the VRF.
NOTE:
family corresponding to the default VRF or an IPv4 address family
corresponding to a non-default VRF.
(OPTIONAL) Enter the following keywords and the interface information:
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
•
For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
•
For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
•
For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
•
For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
•
For a port channel interface, enter the keywords port-channel then a number.
— configure the Management port on the system (either the Primary or
— set the speed for the Management interface.
Use this attribute to start a BGP instance for either a specific address
Advertisement
Chapters
Table of Contents
