Dell S6100 Configuration Manual page 176

Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
9.0.0.0
8.3.19.0
8.3.12.0
8.3.11.1
8.4.2.1
7.6.1.0
Usage Information
If you enable 802.1X multi-supplicant authentication on a port, additional 802.1X configuration details (Port
Authentication status, Untagged VLAN ID, Authentication PAE state, and Backend state) display for each
supplicant, as shown in the following example.
Example
Dell# show dot1x interface tengigabitethernet 1/1/1/1
802.1x information on Te 1/1/1/1:
-----------------------------
Dot1x Status:
Port Control:
Port Auth Status:
Re-Authentication:
Untagged VLAN id:
Guest VLAN:
Guest VLAN id:
Auth-Fail VLAN:
Auth-Fail VLAN id:
Auth-Fail Max-Attempts:
Mac-Auth-Bypass:
Mac-Auth-Bypass Only:
Tx Period:
Quiet Period:
ReAuth Max:
Supplicant Timeout:
Server Timeout:
Re-Auth Interval:
Max-EAP-Req:
Host Mode:
Auth PAE State:
Backend State:
Dell#
Example (mac-
Dell# show dot1x interface tengigabitethernet 1/1/1/1 mac-address
address) 00:00:00:00:00:10
Supplicant Mac: 0 0 0 0 0 10 Lookup for Mac:
176 802.1X
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Added the mac-address option on the C-Series and S-Series.
Introduced on the C-Series, E-Series, and S-Series.
Enable
AUTO
AUTHORIZED(MAC-AUTH-BYPASS)
Disable
400
Enable
100
Disable
NONE
NONE
Enable
Enable
3 seconds
60 seconds
2
30 seconds
30 seconds
3600 seconds
2
SINGLE_HOST
Authenticated
Idle