Dot1X Tx-Period - Dell S6100 Configuration Manual

Version
8.3.11.1
7.6.1.0
7.4.1.0

dot1x tx-period

Configure the intervals at which EAPOL PDUs the Authenticator PAE transmits.
Syntax dot1x tx-period seconds
To return to the default, use the no dot1x tx-period command.
Parameters
seconds
Defaults 30 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
9.0.0.0
8.3.19.0
8.3.12.0
8.3.11.1
7.6.1.0
7.4.1.0
show dot1x cos-mapping interface
Display the CoS priority-mapping table the RADIUS server provides and applies to authenticated supplicants on an 802.1X-enabled system.
Syntax show dot1x cos-mapping interface interface [mac-address mac-address]
Description
Introduced on the Z9000.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
Enter the interval time, in seconds, that EAPOL PDUs are transmitted. The range is from 1
to 65535. The default is 30.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
802.1X 173