Dcb {Ets | Pfc} Enable - Dell S6100 Configuration Manual

Version
9.8(1.0)
9.7(0.0)
9.3(0.0)
Usage Information You can configure up to a maximum of four lossless (PFC) queues. By configuring four lossless queues, you can
configure four different priorities and assign a particular priority to each application that your network is used to
process. For example, you can assign a higher priority for time-sensitive applications and a lower priority for other
services, such as file transfers. You can configure the amount of buffer space to be allocated for each priority and
the pause or resume thresholds for the buffer. This method of configuration enables you to effectively manage and
administer the behavior of lossless queues.
Example Dell(conf)# dcb pfc-queues 4

dcb {ets | pfc} enable

Enable priority flow control or enhanced transmission selection on interface.
Syntax dcb {ets | pfc} enable
•
•
Defaults Enable
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.7(0.0)
9.3 (0.1)
Usage Information
PFC and ETS are enabled by default on the interfaces when DCB is globally enabled (refer to dcb enable). In some
network topology, you may want to disable PFC on an interface and apply link level flow control; Similarly you may
want to disable ETS on an interface and apply QoS bandwidth configurations.
Limitations
•
•
508 Data Center Bridging (DCB)
Description
Introduced on the Z9100–ON.
Introduced on the S6000-ON and Z9500.
Introduced on the S4810 and S6000 platforms.
To disable ETS on interface, use "no dcb ets enable" command.
To disable PFC on interface, use "no dcb pfc enable" command.
Description
Introduced on the S6100.
Introduced on the Z9100–ON.
Introduced on the S6000-ON and Z9500.
Introduced on S6000, S4810, and S4820T.
"dcb-map" CLI on interface is mutually exclusive to "no dcb ets enable" and "no dcb pfc enable".
"pfc priority" CLI is mutually exclusive to "no dcb pfc enable" command.