Managed-Config-Flag - Dell S6100 Configuration Manual

Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.1
Usage Information
Neighbor Discovery Protocol for IPv6 is defined in RFC 2461 as part of the Stateless Address Autoconfiguration
protocol. It replaces the Address Resolution Protocol used with IPv4. It defines mechanisms for solving problems,
such as:
•
•
•
•
•
•
•
•
•
Use the ipv6 neighbor command to manually configure the IPv6 address of a neighbor to be discovered by the
switch.

managed-config-flag

Set the managed address configuration flag.
Syntax managed-config-flag {on | off}
To clear the flag, use the no managed-config-flag {on | off} command.
Parameters
on
off
Defaults None
Command Modes POLICY LIST CONFIGURATION
1034 Neighbor Discovery Protocol (NDP)
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Router discovery: Hosts can locate routers residing on a link.
Prefix discovery: Hosts can discover address prefixes for the link.
Parameter discovery .
Address autoconfiguration — configuration of addresses for an interface .
Address resolution — mapping from IP address to link-layer address.
Next-hop determination.
Neighbor Unreachability Detection (NUD): Determine that a neighbor is no longer reachable on the link.
Duplicate Address Detection (DAD): Allow a node to check whether a proposed address is already in use.
Redirect: The router can inform a node about a better first-hop.
Enter the keyword on to set the managed-config-flag value as ON.
Enter the keyword off to set the managed-config flag value as OFF.