Dell S6100 Configuration Manual page 440

Parameters
ipv4 multicast
ipv4 unicast
ipv6 unicast
peer-group-name
detail
summary
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.8.0
8.3.7.0
7.8.1.0
7.7.1.0
Usage Information
The following describes the show ip bgp peer-group command shown in the following example.
Line beginning
with:
Peer-group
Administratively
shut
BGP version
440 Border Gateway Protocol
(OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to view
information related only to ipv4 multicast routes.
(OPTIONAL) Enter the keyword ipv4 followed by the keyword unicast to view
information related only to ipv4 unicast routes.
(OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to view
information related only to ipv6 unicast routes.
(OPTIONAL) Enter the name of a peer group to view information about that peer group
only.
(OPTIONAL) Enter the keyword detail to view detailed status information of the peers
in that peer group.
(OPTIONAL) Enter the keyword summary to view status information of the peers in that
peer group. The output is the same as that found in the show ip bgp summary
command.
EXEC
EXEC Privilege
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Added the add-path option to the S4810. Output on the S4810 shows the ADDPATH
parameters.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Description
Displays the peer group's name.
Displays the peer group's status if the peer group is not enabled. If you enable the peer
group, this line is not displayed.
Displays the BGP version supported.