Ip Helper-Address Hop-Count Disable - Dell S6100 Configuration Manual

Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
9.0.0.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.9.1.0
7.6.1.0
7.5.1.0
pre-6.2.1.1
Usage Information
You can add multiple DHCP servers by entering the ip helper-address command multiple times. If multiple
servers are defined, an incoming request is sent simultaneously to all configured servers and the reply is forwarded
to the DHCP client.
Dell Networking OS uses standard DHCP ports, that is UDP ports 67 (server) and 68 (client) for DHCP relay
services. It listens on port 67 and if it receives a broadcast, the software converts it to unicast, and forwards to it
to the DHCP-server with source port=68 and destination port=67.
The server replies with source port=67, destination port=67 and Dell Networking OS forwards to the client with
source port=67, destination port=68.

ip helper-address hop-count disable

Disable the hop-count increment for the DHCP relay agent.
Syntax ip helper-address hop-count disable
To re-enable the hop-count increment, use the no ip helper-address hop-count disable command.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Added support for IPv6.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced VRF on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
IPv4 Routing 765