Mode - Dell S6100 Configuration Manual

Version
7.6.1.0
7.4.1.0

mode

To receive or transmit, set LLDP.
Syntax mode {tx | rx}
To return to the default, use the no mode command.
Parameters
tx
rx
Defaults Both transmit and receive.
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
7.6.1.0
7.4.1.0
Related Commands
•
•
Description
Introduced on the C-Series.
Introduced on the E-Series.
Enter the keyword tx to set the mode to transmit.
Enter the keyword rx to set the mode to receive.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
protocol lldp (Configuration)
show lldp neighbors — display the LLDP neighbors.
— enable LLDP globally.
Link Layer Discovery Protocol (LLDP) 963