Set Next-Hop - Dell S6100 Configuration Manual

Parameters
internal
external
type-1
type-2
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
8.1.1.0
7.6.1.0
7.5.1.0
pre-6.1.1.0
Related Commands
•
•
•
•

set next-hop

To specify an IP address as the next hop, configure a filter.
Syntax set next-hop ip-address
To delete the setting, use the no set next-hop ip-address command.
Enter the keyword internal to assign the Interior Gateway Protocol metric of the next
hop as the route's BGP MULTI_EXIT_DES (MED) value.
Enter the keyword external to assign the IS-IS external metric.
Enter the keyword type-1 to assign the OSPF Type 1 metric.
Enter the keyword type-2 to assign the OSPF Type 2 metric.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Implemented the keyword internal.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
set automatic-tag — compute the tag value of the route.
set level — specify the OSPF area for route redistribution.
set metric — specify the metric value assigned to redistributed routes.
set tag — specify the tag assigned to redistributed routes.
Access Control Lists (ACL) 281