Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
8.3.12.0
8.4.1.0
Example
delay
Configure the time delay used before communicating a change in the status of a tracked object to clients.
Syntax
delay {[up seconds] [down seconds]}
To return to the default setting, use the no delay command.
Parameters
seconds
Defaults
0 seconds
Command Modes
OBJECT TRACKING (conf_track_object-id)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
8.3.12.0
8.4.1.0
Usage Information
You can configure an UP and/or DOWN timer for each tracked object to set the time delay before a change in the
state of a tracked object is communicated to clients. The configured time delay starts when the state changes
from UP to DOWN or vice-versa.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S4810.
Introduced.
Enter the number of seconds the object tracker waits before sending a notification about
the change in the UP and/or DOWN state of a tracked object to clients. The range is 0 to
180. The default is 0 seconds.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the S4810.
Introduced.
Object Tracking
1047