Show Hosts - Dell S6100 Configuration Manual

Related Commands
•

show hosts

View the host table and DNS configuration.
Syntax show hosts
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
9.0.0.0
8.3.19.0
8.3.11.1
8.1.1.0
7.6.1.0
7.5.1.0
pre-6.1.1.0
Usage Information The following describes the show hosts command in the following example.
Field
Default domain...
Name/address
lookup...
788 IPv4 Routing
arp retries — set the number of ARP retries in case the system does not receive an ARP reply in response to
an ARP request.
EXEC
EXEC Privilege
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Added support for IPv6 addresses.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the domain name (if configured).
States if DNS is enabled on the system.
• If DNS is enabled, the Name/Address lookup is domain service.
• If DNS is not enabled, the Name/Address lookup is static mapping