Fefd Interval - Dell S6100 Configuration Manual

Version
8.3.7.0
Legacy E-Series
command.
Usage Information FEFD disable command on the interface prevents the interface from running FEFD when FEFD is enabled
globally.
Related Commands
•
•

fefd interval

Set an interval between control packets.
Syntax fefd interval seconds
To return to the default value, use the no fefd interval command.
Parameters
seconds
Defaults 15 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
Legacy E-Series
command.
Usage Information You can set up the interval between control packets using the fefd interval command.
Related Commands
•
948 Layer 2
Description
Introduced on the S4810.
fefd reset — clear an interface in Err-disabled state. It doesn't work until the interface is in err-disabled state.
fefd mode — change FEFD mode on an interface.
Enter a number as the time between FEFD control packets. The range is from 3 to 255
seconds. The default is 15 seconds.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
fefd — enable far-end failure detection.