Bgp Confederation Peers - Dell S6100 Configuration Manual

This command automatically restarts the BGP instance for the configuration to take effect.
Related Commands
•

bgp confederation peers

Specify the autonomous systems (ASs) that belong to the BGP confederation.
Syntax bgp confederation peers as-number [...as-number]
To return to the default, use the no bgp confederation peers command.
Parameters
as-number
...as-number
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage Information
All the routers in the Confederation must be 4 byte or 2 byte identified routers. You cannot mix them.
The autonomous systems configured in this command are visible to the EBGP neighbors. Each autonomous system
is fully meshed and contains a few connections to other autonomous systems.
After specifying autonomous systems numbers for the BGP confederation, recycle the peers to update their
configuration.
Related Commands
•
350 Border Gateway Protocol
bgp four-octet-as-support
Enter the AS number. The range is from 0 to 65535 (2 byte), from 1 to 4294967295 (4
byte), or from 0.1 to 65535.65535 (dotted format).
(OPTIONAL) Enter up to 16 confederation numbers. The range is from 0 to 65535 (2
byte), from 1 to 4294967295 (4 byte), or from 0.1 to 65535.65535 (dotted format).
Description
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series. Added support for the 4-byte format.
bgp confederation identifier
— enable 4-byte support for the BGP process.
— configure a confederation ID.