Interface Range - Dell S6100 Configuration Manual

Version
6.4.1.0
Usage Information You cannot delete the Null interface. The only configuration command possible in a Null interface is ip
unreachables.
Example
Dell(conf)# interface null 0
Dell(conf-if-nu-0)#
Related Commands
•
•
•
•
•

interface range

This command permits configuration of a range of interfaces to which subsequent commands are applied (bulk configuration). Using the
interface range command, you can enter identical commands for a range of interface.
Syntax interface range interface {[stack/]slot/port[/subport] | port} — {[stack/]slot/
port[/subport] | port}, interface {[stack/]slot/port[subport] | port} —
{[stack/]slot/port[subport] | port},...
Parameters
interface
{[stack/]slot/
port[subport] |
port} —
{[stack/]slot/
port[subport] |
port}, interface
{[stack/]slot/
port[subport] |
port} —
{[stack/]slot/
port[subport] |
port},...
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
680 Interfaces
Description
Introduced
interface — configure a physical interface.
interface loopback — configure a Loopback interface.
interface port-channel — configure a port channel.
interface vlan — configure a VLAN.
ip unreachables — enable generation of internet control message protocol (ICMP) unreachable messages.
Enter interface range and one of the interfaces and then the interface information.
Select the range of interfaces for bulk configuration. You can enter up to six comma-
separated ranges. Spaces are not required between the commas. The ranges can include
VLANs, port-channels, and physical interfaces.
• For a port channel interface, enter the keywords port-channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a Tunnel interface, enter the keyword Tunnel then a number from 1 to 16383.