Dot1X Supplicant-Timeout - Dell S6100 Configuration Manual

Dot1x Status:
Port Control:
Port Auth Status:
Re-Authentication:
Untagged VLAN id:
Guest VLAN:
Guest VLAN id:
Auth-Fail VLAN:
Auth-Fail VLAN id:
Auth-Fail Max-Attempts:
Critical VLAN:
Critical VLAN id:
Mac-Auth-Bypass:
Mac-Auth-Bypass Only:
Static-MAB:
Static-MAB Profile:
Tx Period:
Quiet Period:
ReAuth Max:
Supplicant Timeout:
Server Timeout:
Re-Auth Interval:
Max-EAP-Req:
Host Mode:
Auth PAE State:
Backend State:

dot1x supplicant-timeout

Configure the amount of time after which exchanges with the supplicant time-out.
Syntax dot1x supplicant-timeout seconds
To return to the default, use the no dot1x supplicant-timeout command.
Parameters
seconds
Defaults 30 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
9.0.0.0
8.3.19.0
8.3.12.0
172 802.1X
Enable
AUTO
AUTHORIZED (STATIC-MAB)
Enable
400
Enable
400
Enable
400
3
Enable
400
Disable
Disable
Enable
Sample
30 seconds
60 seconds
2
30 seconds
30 seconds
60 seconds
2
SINGLE_HOST
Authenticated
Idle
Enter a time-out value in seconds. The range is from 1 to 300, where 300 is
implementation dependant. The default is 30.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.