Rep 12.19 Stacker Sensor - Xerox workcentre 5335 series Service Manual

(3)Remove Stacker Motor.
Figure 4 Removing the Stacker Motor)
Replacement
1. Reverse the removal procedure for replacement.
2. Install the Stacker Motor as shown in
Figure 5 Installing the Stacker Motor
Initial Issue
WorkCentre 5335 Family Service Documentation
Figure 5.
BUS Updated 12/2011

REP 12.19 Stacker Sensor

Parts List on PL 22.8
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the Integrated Office Finisher from the machine
3. Remove the Rear Cover (PL 22.1)
4. Turn over the Integrated Office Finisher.
5. Remove the Tray Cover (PL 22.2)
6. Remove the Stacker Sensor Assembly
(1)Release the wire from the Clamp.
(2)Remove Screw.
(3)Remove Stacker Sensor Assembly.
(4)Disconnect the Sensor Connector and remove Sensor from Bracket (5)
Figure 1 Removing the Stacker Stack Sensor Assembly
Replacement
1. Reverse the removal procedure for replacement.
07/2011
4-121
(REP 12.1).
(Figure 1):
Repairs & Adjustments
REP 12.18, REP 12.19