Rep 19.6 Hcf Feed Shaft; Rep 19.7 Hcf Retard Lever Spring - Xerox workcentre 5335 series Service Manual

REP 19.6 HCF Feed Shaft

Parts List on PL 10.5
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the HCF Feeder (REP 19.2)
3. Place the Feeder on a flat surface.
4. Open the Upper Feeder Assembly by releasing the green lever.
5. Remove the Nudger Roll by squeezing the roll's shaft at both ends (with the thumb and
forefinger of one hand) and lifting the roll up and out of the HCF.
6. Remove the E-Ring and bearing on the Feed Shaft (at the Nudger Roll end of the shaft).
7. Move the bearing at the opposite end of the shaft to the right, and slide the Feed Shaft to
the right to remove.
Replacement
1. To install, carry out the removal steps in reverse order.
Repairs & Adjustments
REP 19.6, REP 19.7

REP 19.7 HCF Retard Lever Spring

Parts List on
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the HCF Feeder
3. Place the Feeder on a flat surface and release the green Lever to open the Upper Feeder
Assembly.
4. Remove the Lower Chute (2 screws).
5. Remove the plastic Cover by removing (4) screws.
6. Remove the Retard Roll.
7. Remove the E-Rings on the Lever and Spring.
8. Remove the Lever.
9. Remove the Spring
07/2011
4-184
BUS Updated 12/2011
PL 10.6
(REP 19.2)
(Figure 1).
Lever
Spring. Note how exten-
sion fits into Lever.
Lower Chute
Figure 1 Removing the Retard Lever Spring
WorkCentre 5335 Family Service Documentation
Retard
Roll
Cover
Initial Issue