Releasing The Cable Ends From The Lift Shaft; Removing The Rear Tray Cables; Rear Tray Cables Details Diagram - Xerox workcentre 5335 series Service Manual

5. When both sections of the cable are slack, disengage the Lift Shaft from the frame and
slide the Tray Cable Pulley to the front of the Lift Shaft to release the Rear Lift Cable ends
that are trapped in the pocket underneath the Tray Cable Pulley
2
Slide the Tray Cable
Pulley to the front
1
Disengage the Lift Shaft
from the frame
Figure 4 Releasing the Cable ends from the Lift Shaft
6. Remove the Rear Tray Cable (Figure
Repairs & Adjustments
REP 19.4
(Figure 4).
3
Remove the cable
ends from the shaft
5, Figure 6).
BUS Updated 12/2011
1
Remove the E-Ring (1), Wire
Guide (1), and Pulley (1)
Figure 5 Removing the Rear Tray Cables
Figure 6 Rear Tray Cable details
07/2011
4-180
2
Remove the Cables
Initial Issue
WorkCentre 5335 Family Service Documentation