Rep 12.26 Front /Rear Tamper Motor Assembly - Xerox workcentre 5335 series Service Manual

REP 12.26 Front /Rear Tamper Motor Assembly

Parts List on PL 22.10
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the Integrated Office Finisher from the machine
3. Remove the Compiler Assembly (REP
4. Remove the Bracket Assembly (Figure
(1)Release Clamps (2) and remove the wire.
(2)Remove Screws (2).
(3)Remove Bracket Assembly.
Figure 1 Removing the Bracket Assembly
5. Remove the KL-Clips from the Eject Shaft
(1)Remove KL-Clips (2).
Repairs & Adjustments
REP 12.26
(PL 22.1).
12.20)
1):
(Figure 2):
BUS Updated 12/2011
Figure 2 Removing the KL-Clips
6. Remove the Eject Shaft from the Front/Rear Tamper Motor Assembly
(1)Move Bearings (2) in the direction of the arrow.
(2)Remove Eject Shaft in the direction of the arrow.
(3)Remove Belt from Pulley.
Figure 3 Removing the Eject Shaft
7. Remove the Front/Rear Tamper Motor Assembly
(1)Remove Self-tapping Screws (2).
07/2011
4-132
(Figure 3):
(Figure 4):
Initial Issue
WorkCentre 5335 Family Service Documentation