Rep 13.17 Compiler Tray Assembly (Office Finisher Lx) - Xerox workcentre 5335 series Service Manual

Finisher Stapler Assembly
Figure 2 Removing the Finisher Stapler Assembly
Replacement
Reverse the removal procedure for replacement.
Perform ADJ 12.2 Finisher LX Booklet Crease/Staple Position
Repairs & Adjustments
REP 13.16, REP 13.17
Connectors (2) Screws (3)
07/2011
4-150
BUS Updated 12/2011

REP 13.17 Compiler Tray Assembly (Office Finisher LX)

Parts List on PL 23.12
Removal
1. Switch off the power and disconnect the power cord.
2. Undock the Finisher (REP 13.5).
3. Remove the Front Cover (REP 13.6).
4. Remove the Rear Upper Cover (REP
5. Remove the Foot Cover (REP 13.10).
6. Remove the Stacker Lower Cover (REP
7. Remove the Stacker Tray (REP 13.20).
8. Remove the Stacker Upper Cover (REP
9. Remove the Eject Cover (REP 13.9).
10. Preparing to remove the Eject Roller Shaft
Figure 1 Removing the E-ring and brass bearing
11. Remove the Eject Roll Shaft (Figure
(1) Remove the E-ring and brass bearing from the front of the shaft.
(2) Remove the E-ring,
(3) Slide the Eject Roller shaft toward the front.
(4) Remove the Gear, and brass bushing.
(5) Remove the Eject Roll from the Finisher.
13.7).
13.11).
13.12).
(Figure 1).
2).
Initial Issue
WorkCentre 5335 Family Service Documentation