Rep 12.27 Front Tamper Home Sensor - Xerox workcentre 5335 series Service Manual

REP 12.27 Front Tamper Home Sensor

Parts List on PL 22.10
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the Integrated Office Finisher from the machine
3. Remove the Inner Front Cover (PL 22.1)
4. Remove the Rear Cover (PL 22.1)
5. Turn over the Integrated Office Finisher.
6. Remove the Bottom Cover (PL 22.2)
7. Remove the Connector Bracket (Figure
(1)Release Clamps (3) and remove the wire.
(2)Disconnect Connectors (5).
(3)Remove Screws (2).
(4)Remove Connector Bracket.
Figure 1 Removing the Connector Bracket
8. Remove the Bottom Plate (Figure 2):
(1)Release Clamps (5) and remove the wire.
(2)Disconnect Connectors (8).
(3)Remove Wire from Hook.
(4)Remove Screws (4).
(5)Remove Bottom Plate.
Repairs & Adjustments
REP 12.27
(REP 12.1).
1):
BUS Updated 12/2011
Figure 2 Removing the Bottom Plate
9. Remove the Front Tamper Home Sensor Assembly
(1)Remove Screw.
(2)Remove Front Tamper Home Sensor Assembly.
Figure 3 Removing the Front Tamper Home Sensor Assembly
10. Remove the Front Tamper Home Sensor Assembly
(1)Disconnect Connector.
(2)Remove Front Tamper Home Sensor Assembly.
07/2011
4-134
(Figure 3):
(Figure 4):
Initial Issue
WorkCentre 5335 Family Service Documentation