Xerox workcentre 5335 series Service Manual page 1187

Figure 2 Removing the Bottom Plate
9. Remove the Stacker Tray (Figure 3):
(1)Release wires from Clamps (5)
(2)Disconnect the Connector
(3)Remove Screws (7)
(4)Remove the Stacker Tray
Figure 3 Removing the Stacker Tray
10. Remove the screws securing the Eject/Set Clamp Motor Assembly
(1)Release Clamps (2) and remove the wire.
(2)Remove Screws (2).
(3)Remove Self-tapping Screws (2).
Repairs & Adjustments
REP 12.23
11. Remove the Eject/Set Clamp Motor Assembly
(1)Remove Belts (2) from Pulley.
(2)Remove Eject/Set Clamp Motor Assembly.
(Figure 4):
Replacement
1. Reverse the removal procedure for replacement.
07/2011
4-128
BUS Updated 12/2011
Figure 4 Removing Screws
(Figure
Figure 5 Removing the Eject/Set Clamp Motor Assembly
WorkCentre 5335 Family Service Documentation
5):
Initial Issue