Rep 12.29 Stack Height Sensor - Xerox workcentre 5335 series Service Manual

Figure 2 Removing the Bottom Plate
7. Remove the Eject Home Sensor (Figure
(1)Release Clamp and remove the wire.
(2)Disconnect Connector.
(3)Remove Eject Home Sensor from the bracket.
Figure 3 Removing the Eject Home Sensor
Replacement
1. Reverse the removal procedure for replacement.
Repairs & Adjustments
REP 12.28, REP 12.29
3):
BUS Updated 12/2011

REP 12.29 Stack Height Sensor

Parts List on PL 22.10
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the Integrated Office Finisher from the machine
3. Remove the Inner Front Cover
4. Remove the Rear Cover (PL 22.1)
5. Turn over the Integrated Office Finisher.
6. Remove the Bottom Cover (PL
7. Remove the Connector Bracket
(1)Release Clamps (3) and remove the wire.
(2)Disconnect Connectors (5).
(3)Remove Screws (2).
(4)Remove Connector Bracket.
Figure 1 Removing the Connector Bracket
8. Remove the Bottom Plate (Figure
(1)Release Clamps (5) and remove the wire.
(2)Disconnect Connectors (8).
(3)Remove Wire from Hook.
(4)Remove Screws (4).
(5)Remove Bottom Plate.
07/2011
4-136
(REP 12.1).
(PL 22.1)
22.2)
(Figure 1):
2):
WorkCentre 5335 Family Service Documentation
Initial Issue