Table of Contents
Advertisement
ADJ 6.9 UI Touch Panel Alignment
Parts List on
PL 1.7
Purpose
To align the position of the buttons on the display and the Touch Panel so that the user can
select the contents on the display using the Touch Panel.
NOTE: Any substitute used as a Touch Pen for this adjustment should have a pointed tip (such
as a ball point pen) Be careful not to damage the surface of the UI.
Adjustment
1.
Turn ON the power while holding down the [0], [1], [3] buttons.
The following appears on the display
Figure 1 Touch Screen Display
2.
Using the Touch Pen, touch the intersections of the vertical and horizontal lines, P1 to P9
in sequence. (Keep the Touch Pen on each point for approx. 1 sec., then proceed to the
next point)
After pressing all the buttons, the machine automatically calculates the difference
between the coordinates and the correction values. This calculation takes approx. 0.1
sec.
3.
After a few seconds, turn the power OFF then ON. The UI may be used after reboot as
the data has been corrected.
NOTE: Complete the whole procedure before turning the machine OFF. If power is turned
OFF during the adjustment, the "before" data will be restored.
Initial Issue
WorkCentre 5335 Family Service Documentation
(Figure
1)
BUS Updated 12/2011
07/2011
4-207
Repairs & Adjustments
ADJ 6.9
Advertisement
Table of Contents
