Rep 13.13 Stack Height Sensors 1 And 2 (Office Finisher Lx); Rep 13.14 Sub Paddle Solenoid Assembly (Office Finisher Lx) - Xerox workcentre 5335 series Service Manual

REP 13.13 Stack Height Sensors 1 and 2 (Office Finisher
LX)
Parts List on PL 23.11
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the Rear Upper Cover (REP
3. Remove the Stack Height Sensor 1 or 2
(1) Disconnect the connector.
(2) Remove the Sensor.
Stack Height Sensor 1
Figure 1 Removing the Stack Height Sensor 1 or 2
Initial Issue
WorkCentre 5335 Family Service Documentation
13.7).
(Figure 1).
1
Discon-
nect the
connec-
tor
2
Remove
the Sen-
sor
Stack Height Sen-
sor 2
BUS Updated 12/2011
REP 13.14 Sub Paddle Solenoid Assembly (Office Finisher
LX)
Parts List on PL 23.10
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the Eject Cover (REP
3. Remove the Sub Paddle Solenoid Assembly
(1) Disconnect the connector.
(2) Remove the wires from the wire clamps
(3) Remove the screw (1) from the Sub Paddle Solenoid Assembly.
(4) Remove the Sub Paddle Solenoid Assembly.
Figure 1 Removing the Sub Paddle Solenoid Assembly
07/2011
4-147
13.9).
(Figure 1).
Repairs & Adjustments
REP 13.13, REP 13.14
1
Discon-
nect the
Connec-
tor
2
Remove
wires
from
wire
clamp
3
Remove
the
screw
(1)