Rep 13.29 Front/Rear Carriage Assembly (Office Finisher Lx); Rep 13.30 Booklet Pwb (Office Finisher Lx) - Xerox workcentre 5335 series Service Manual

REP 13.29 Front/Rear Carriage Assembly (Office Finisher
LX)
Parts List on PL 23.7
Removal
NOTE: Ensure that the Stacker Tray is in the top position.
1. Switch off the power and disconnect the power cord.
2. Remove the Finisher Front Cover (REP
3. Remove the Rear Upper and Rear Lower Covers
4. Remove the Stacker Tray (REP 13.20).
5. Removing the Carriage Assembly (Figure
(1) Disconnect and remove the Spring.
NOTE: The Carriage Bearings (2 each Assembly) are not fastened to the shafts. Use care to
catch the Bearings when the Carriage Assembly is removed.
(2) With a 6 inch common screwdriver, move the belt Clamp latch aside and remove
the Stacker Belt and Carriage Assembly.
Figure 1 Removing the Carriage Assembly
Replacement
NOTE: Ensure that the Front and Rear Carriage Assemblies are installed at the same height.
1. Install the Front or Rear Carriage Assemblies in the reverse order of removal.
Initial Issue
WorkCentre 5335 Family Service Documentation
13.6).
(REP 13.7, REP 13.8).
1).
1
Remove
the
Spring
2
Release
latch and
remove
Belt
3
Remove
the Car-
riage
Assem-
bly
BUS Updated 12/2011

REP 13.30 Booklet PWB (Office Finisher LX)

Parts List on PL 23.21
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the Booklet PWB Cover
3. Remove the Booklet PWB (Figure
(1) Disconnect the Connectors (5).
(2) Remove the Screws (4).
(3) Remove the Booklet PWB.
Screws
Screws
Figure 1 Removing the Booklet PWB
Replacement
1. Reverse the removal procedure for replacement.
07/2011
4-167
(REP 13.35).
1).
Connectors
Booklet
PWB
Repairs & Adjustments
REP 13.29, REP 13.30