Rep 12.23 Eject/Set Clamp Motor Assembly - Xerox workcentre 5335 series Service Manual

Figure 4 Eject Belt Alignment
Initial Issue
WorkCentre 5335 Family Service Documentation

REP 12.23 Eject/Set Clamp Motor Assembly

Parts List on
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the Integrated Office Finisher from the machine
3. Remove the Inner Front Cover
4. Remove the Rear Cover
5. Turn over the Integrated Office Finisher.
6. Remove the Bottom Cover
7. Remove the Connector Bracket
(1)Release Clamps (3) and remove the wire.
(2)Disconnect Connectors (5).
(3)Remove Screws (2).
(4)Remove Connector Bracket.
8. Remove the Bottom Plate
(1)Release Clamps (5) and remove the wire.
(2)Disconnect Connectors (8).
(3)Remove Wire from Hook.
(4)Remove Screws (4).
(5)Remove Bottom Plate.
07/2011
4-127
BUS Updated 12/2011
PL 22.9
(PL 22.1)
(PL 22.1)
(PL 22.2)
(Figure 1):
Figure 1 Removing the Connector Bracket
(Figure 2):
(REP 12.1).
Repairs & Adjustments
REP 12.22, REP 12.23