Rep 19.5 Hcf Feed, Nudger, Retard Rolls - Xerox workcentre 5335 series Service Manual

REP 19.5 HCF Feed, Nudger, Retard Rolls

Parts List on PL 10.5, PL 10.6
Removal
NOTE: Remove and replace the Retard/Feed/Nudger Rolls at the same time.
1. Switch off the power and disconnect the power cord.
2. Open the Feeder Top Cover.
3. Release the green Lever to open the Upper Feeder Assembly to reveal the (3) rolls.
NOTE: For reference purposes, the single roll in the Upper Feeder Assembly is the
Nudger roll. The double roll in the Upper Feeder Assembly is the Feed Roll. The larger
double roll in the Lower Feeder component is the Retard Roll.
4. Remove each roll by squeezing the roll's shaft at both ends and lifting the roll up and out
of the HCF (Figure 1).
Figure 1 Removing rolls
Initial Issue
WorkCentre 5335 Family Service Documentation
Replacement
1. Install each new roll by squeezing its shaft at both ends and sliding the roll into place.
2. check that the rolls turn freely.
3. Flip down the Upper Feeder Assembly.
4. Close the Feeder Top Cover of the HCF.
07/2011
4-183
BUS Updated 12/2011
Repairs & Adjustments
REP 19.5