Rep 13.1 H-Transport Assembly (Office Finisher Lx); Rep 13.2 Hole Punch Assembly (Office Finisher Lx) - Xerox workcentre 5335 series Service Manual

REP 13.1 H-Transport Assembly (Office Finisher LX)

Parts List on PL 23.1
Removal
1. Switch off the power and disconnect the power cord.
2. Undock the Finisher Assembly (REP
3. Move the H-Transport Assembly (Figure
2
Remove Screws (2)
4
Remove the H-
Transport
3
Remove Docking
Plate.
Figure 1 Removing the Docking Bracket
Replacement
1. To install, carry out the removal steps in reverse order.
Initial Issue
WorkCentre 5335 Family Service Documentation
13.5).
1).
1
Disconnect Har-
ness
BUS Updated 12/2011

REP 13.2 Hole Punch Assembly (Office Finisher LX)

Parts List on PL 23.2
Removal
1. Switch off the power and disconnect the power cord.
2. Open the H-Transport Top Cover and hold it open.
3. Open the H-Transport Front Cover.
4. Remove the Hole Punch Assembly
2
Remove the Connector Cover and
disconnect the connector
Figure 1 Removing the Hole Punch Assembly
Replacement
1. Insert the Hole Punch Assembly rear locating pin into the H-Transport frame.
2. Install the Hole Punch Assembly in reverse order of removal.
3. Perform ADJ 12.1 Finisher LX Hole Punch Position
07/2011
4-139
(Figure 1).
1
Disconnect the cable
clamp
Repairs & Adjustments
REP 13.1, REP 13.2
3
Remove
the
Thumb
Screw
Front
Cover
4
Remove
the Hole
Punch
Assem-
bly