Xerox workcentre 5335 series Service Manual page 1190

Figure 2 Removing the KL-Clips
6. Remove the Eject Shaft from the Front/Rear Tamper Motor Assembly
(1)Move Bearings (2) in the direction of the arrow.
(2)Remove Eject Shaft in the direction of the arrow.
(3)Remove Belt from Pulley.
Figure 3 Removing the Eject Shaft
Replacement
1. Reverse the removal procedure for replacement.
Initial Issue
WorkCentre 5335 Family Service Documentation
2. Install and align the Eject Belt with marks on the Pulleys
(Figure 3):
07/2011
4-131
BUS Updated 12/2011
(Figure 4) (Figure
Figure 4 Align Eject Belt
Figure 5 Align Eject Belt
Repairs & Adjustments
5):
REP 12.25