Removing The Eject Roll Shaft/The Compiler Tray Screw - Xerox workcentre 5335 series Service Manual

1
2
Remove the E-ring
Slide the shaft
toward front
Figure 2 Removing the Eject Roll Shaft
12. Remove the Compiler Tray screw (Figure
Initial Issue
WorkCentre 5335 Family Service Documentation
3
Remove
the Gear
and
brass
bearing
4
Remove the shaft
3).
BUS Updated 12/2011
NOTE: Notice the position of
the Set Clamp Holders
Figure 3 Removing the Compiler Tray screw
NOTE: Notice the position and orientation of the Set Clamp Holders.
13. Disconnect the springs from the Set Clamp Holders (3)
07/2011
4-151
(Figure 4).
Repairs & Adjustments
REP 13.17