Table of Contents
Advertisement
Figure 2 Crease Assembly
2.
Perform
ADJ 12.2
Finisher LX Booklet Crease/Staple Position
Initial Issue
WorkCentre 5335 Family Service Documentation
Locating Pins
07/2011
4-161
BUS Updated 12/2011
REP 13.19 Stacker Elevator Motor (Office Finisher LX)
Parts List on
PL 23.7
Removal
1.
Switch off the power and disconnect the power cord.
2.
Remove the Finisher Rear Upper Cover
3.
Disconnect P/J8988 on the Finisher Control PWB.
4.
Release the wires from the cable clamps.
5.
Remove the wires from the wire guide, remove the screws (2) and move the wire guide to
one side.
6.
Remove the screws (2) from the motor mount using a 5.5 mm combination wrench.
7.
Remove the Stacker Elevator Motor.
Replacement
Install in reverse order of removal procedure.
(REP
13.7).
Repairs & Adjustments
REP 13.18, REP 13.19
Advertisement
Table of Contents
