Rep 13.24 Finisher Lvps (Office Finisher Lx); Rep 13.25 Eject Motor (Office Finisher Lx) - Xerox workcentre 5335 series Service Manual

REP 13.24 Finisher LVPS (Office Finisher LX)

Parts List on PL 23.16
Removal
1. Switch off the power and disconnect the power cord.
2. Remove the Rear Lower Cover (REP
3. Remove the Finisher LVPS (Figure 1).
(1) Disconnect the Connectors (2).
(2) Remove the Screws (4).
(3) Remove the Finisher LVPS.
Finisher LVPS Screw
Screw
Figure 1 Removing the Finisher LVPS
Replacement
Reverse the removal procedure for replacement.
Repairs & Adjustments
REP 13.24, REP 13.25
13.8).
Connector Screw
Connector
Screw
BUS Updated 12/2011

REP 13.25 Eject Motor (Office Finisher LX)

Parts List on PL 23.11
Removal
1. Switch off the power and disconnect the power cord.
2. Undock the Finisher (REP 13.5).
3. Remove the Booklet Maker (REP
4. Remove the Rear Upper Cover
5. Remove the Eject Motor Assembly
6. Remove the Eject Motor.
(1) Remove the screws (2)
(2) Remove the Eject motor
Replacement
1. To install, carry out the removal steps in reverse order.
07/2011
4-164
13.31).
(REP 13.7).
(REP 13.22).
WorkCentre 5335 Family Service Documentation
Initial Issue