Xerox workcentre 5335 series Service Manual page 1184

(2)Remove Actuator.
(3)Remove E-Clip.
(4)Remove Bearing.
Figure 4 Removing the Actuator and Bearing
8. Remove the Bearing (Figure 5):
(1)Remove E-Clip.
(2)Remove Bearing.
Figure 5 Removing the Bearing
9. Remove the Set Clamp Shaft (Figure
(1)Move Set Clamp Shaft in the direction of the arrow.
Initial Issue
WorkCentre 5335 Family Service Documentation
6):
BUS Updated 12/2011
(2)Remove Belts (3) from Pulleys (3).
(3)Remove Set Clamp Shaft in the direction of the arrow.
Figure 6 Removing the Set Clamp Shaft
Replacement
1. Reverse the removal procedure for replacement.
2. Install and align the Eject Belt with marks on the Pulleys
Figure 7 Installing the Eject Belt
07/2011
4-125
(Figure 7):
Repairs & Adjustments
REP 12.21