Table of Contents
Advertisement
Replacement
1.
Position the HCF Feeder's bottom rail-following feet (2) onto the internal HCF rail.
2.
Slide the HCF Feeder back into the HCF until it seats.
Do not over tighten the HCF Feeder screws.
3.
Reinstall the two securing screws and tighten until snug.
Repairs & Adjustments
REP 19.2, REP 19.3
CAUTION
BUS Updated 12/2011
REP 19.3 HCF Undocking
Removal
1.
Switch off the power and disconnect the power cord.
2.
Unplug the HCF Power Cable connected to the left rear of the copier/printer.
3.
Grasping the HCF by its upper corners, pull the HCF away from the copier/printer to
expose the HCF Docking Base
Docking Points
HCF Docking Base
Docking Latch Spring Lever
Figure 1 Exposing the docking base
4.
Release the Docking Latch Spring Lever on the right side of the Docking Base.
5.
Pull the HCF away from the copier/printer to un-dock it from the copier/printer.
Replacement
1.
Push the HCF toward the two Docking Points on the left side of the printer.
2.
Align the holes in the HCF Docking Base with the Docking Points on the printer/copier.
NOTE: Rotate the Caster of the copier/printer so that it does not interfere with docking.
3.
Push the HCF into place.
4.
Reattach the HCF Power Cable.
07/2011
4-178
(Figure
1).
WorkCentre 5335 Family Service Documentation
Initial Issue
Advertisement
Table of Contents
