NEC Univerge sv8500 Manual page 337

COMMAND No. SUB COMMAND
7 FAXERRORDETECT
8 FAXRECVPAD
9 FAXSENDPAD
10 HEALTHCHECKTIMER
11 INTERFACE
12 IPADDRESS
13 MUSICTYPE
14 OPEN
15 PAD
SHOW 16 PRERINGING
17 RINGFREQ
18 RINGVOLTAGE
19 SENDPAD
20 STARTPORT
21 STUTTERDT
22 SYNCRINGING
23 VALUE
24 VERSION
25 VLAN
DELETE VLAN
SAVE CONFIGDATA
GET CONFIGDATA
PUT CONFIGDATA
REBOOT -
EXIT -
Enter the command, sub command and required parameters after the prompt (2A-MC>) is shown. Parameters
vary depending on the kind of command specified. When the data (command name, sub command name, pa-
rameter) is specified correctly, the command executes the required data processing, and then displays the pro-
cessed result on the screen. To finish this program, input EXIT after a prompt.
List of Maintenance Command (Continued)
To show Change Effective Timer of FAX
To show FAX receiver PAD value
To show FAX sender PAD value
To show health check timer value
To show communication speed for LAN interface
To show IP Address
To show Music-on-Hold type
To show Open/Reverse
To show default receiver PAD value
To show Pre-Ringing
To show the frequency of Ringer
To show Ringer Voltage
To show default sender PAD value
To show RTP Start Port
To show Stutter Dial Tone
To show Synchronous Ringer mode
To show Balancing Network (BNW)
To show the release version of firmware and hardware
To show VLAN
To delete VLAN
To save the configuration data in RAM drive to Flash ROM
To download Configuration Data from specified TFTP server
To upload Configuration Data to specified TFTP server
To reboot the MC
To exit the maintenance command
VOL.2-84
Analog 2MC (Analog Media Converter)
FUNCTION REMARKS