How To Use Maintenance Command - NEC Univerge sv8500 Manual

4.4.5

How to Use Maintenance Command

"DRS (Device Registration Server)" used in this section refers to the Telephony Server. The Telephony
Note:
Server acts as DRS, where Analog 2MC is registered.
1. Connect a PC to the MC using the RS-232C straight-through cable and run terminal software (e.g. Hyper-
Terminal) on the PC.
2. Set the parameter of the terminal software as follows:
• Port: COM1
• Baud Rate: 9600 bps
• Data: 8 bits
• Parity: None
• Stop Bit: 1
• Flow Control: None
3. Enter usrConsole after the prompt. Then the following prompt appears.
2A-MC>_
Something similar to the following is displayed when Analog 2MC is turned on.
MC-ID: 00004c323232
Starting 2A-MC boot program.......
--- Online start --- (wait 30sec)
Attached TCP/IP interface to axDev unit 0
Attaching network interface lo0... done.
NFS client support not included.
Adding 4521 symbols for standalone.
------//----------------------------------------//---
2 Port Analog Media Converter
---//----------------------------------------//------
->
->
->
->
->usrConsole
2A-MC Maintenance command Version 1.00
2A-MC>_
(Machine Name > : default)
*Firmware SP-3753
*Compiled on Nov 2 2002 21:57:46
Enter usrConsole at this prompt.
Analog 2MC (Analog Media Converter)
( 01.00 )
2001.07.19
VOL.2-82