Policy-Map-Output - Dell Force10 Z9000 Reference Manual

Version 8.2.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
pre-Version
6.1.1.1
Usage The input policy map is used to classify incoming traffic to different flows using class-map, QoS
Information policy, or incoming packets DSCP. This command enables Policy-Map-Input Configuration
mode (conf-policy-map-in).
Related
service-queue
Commands
policy-aggregate
service-policy input

policy-map-output

Create an output policy map.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name
command.
Parameters
policy-map-name
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 7.6.1.0
pre-Version
6.1.1.1
Usage The output policy map is used to assign traffic to different flows using QoS policy. This
Information command enables Policy-Map-Output Configuration mode (conf-policy-map-out).
Policy name character limit increased from 16 to 32.
Introduced on the S-Series.
Introduced on the C-Series.
Expanded to add support for Layer 2.
Introduced on the E-Series.
– assigns a class map and QoS policy to different queues.
– allows an aggregate method of configuring per-port QoS using policy maps.
– applies an input policy map to the selected interface.
Enter the name for the policy map in character format (16 characters
maximum).
Introduced on the Z9000.
Introduced on the S4810.
Policy name character limit increased from 16 to 32.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
1203