Dcb-Map Sfm All Backplane All - Dell Z9500 Command Reference Manual

Use the dcb-map command to create a DCB map to specify PFC and ETS settings
and apply it on Ethernet ports. After you apply a DCB map to an interface, the PFC
and ETS settings in the map are applied when the Ethernet port is enabled. DCBx is
enabled on Ethernet ports by default.
The dcb-map command is supported only on physical Ethernet interfaces.
To remove a DCB map from an interface, enter the no dcb-map map-name
command in Interface configuration mode.

dcb-map sfm all backplane all

Assign the specified DCB Map on all backplane ports of the switch linecard.
Syntax
dcb-map sfm all backplane all <dcb-map-name>
Parameters
map-name
Defaults none
Command GLOBAL CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
Usage
You can configure DCB-MAP on backplane ports in both leaf and spine. To remove
Information
a DCB Map from all backplane ports. To remove a DCB Map from all backplane
ports, enter the [no] dcb-map sfm all backplane all <dcb-map-name>
command in Interface configuration mode.
Data Center Bridging (DCB)
Enter a DCB map name. The maximum number of
alphanumeric characters is 32.
Description
Introduced on the Z9500.
625