Cam-Acl (Configuration) - Dell Force10 S4810P Reference Manual

cam-acl (Configuration)

Select the default CAM allocation settings or reconfigure a new CAM allocation for Layer 2, IPv4, and IPv6 ACLs, Layer 2
and Layer 3 (IPv4) QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address validation for DHCP, Ethernet
Connectivity Fault Management (CFM) ACLs, OpenFlow, and Policy-based Routing (PBR).
C-Series, S-Series, S4810
Syntax cam-acl {default | l2acl number ipv4acl number ipv6acl number
ipv4qos number l2qos number l2pt number ipmacacl number ecfmacl
number [vman-qos | vman-dual-qos number] ipv4pbr
number}openflow {4|8}
Parameters
default
l2acl
ipv4acl
ipv6acl
ipv4qos
l2qos
l2pt
ipmacacl
ecfmacl
[vman-qos |
vman-dual-qos
number ] ipv4pbr
number openflow
{4|8}
Command Modes CONFIGURATION
Command History
Version 9.1.(0.0)
Version 8.3.10.2
Version 8.3.10.0
Version 8.3.1.0
Version 8.2.1.0
Version 7.8.1.0
572
Use the default CAM profile settings and set the CAM as follows:
•
•
•
•
•
•
number
Allocate space to each CAM region.
number
Enter the CAM profile name followed by the amount of CAM space to
number ,
be allotted. The total space allocated must equal 13. The range for
number
ipv4acl is 1 to 4. The ipv6acl range must be a factor of 2.
number ,
Enter 4 or 8 for the number of OpenFlow FP blocks.
number
number
•
number
•
Added support for OpenFlow.
Clarified block information for the S4810.
Introduced on the S4810.
Added the keywords ecfmacl, vman-qos, and vman-dual-
qos.
Introduced on the S-Series.
Introduced on the C-Series.
L3 ACL (ipv4acl): 4
L2 ACL(l2acl): 5
IPv6 L3 ACL (ipv6acl): 0
L3 QoS (ipv4qos): 1
L2 QoS (l2qos): 1
OpenFlow: 0 (disabled)
4: Creates 242 entries for use by the OpenFlow controller (256
total entries minus the 14 entries reserved for internal
functionality)
8: Creates 498 entries for use by the OpenFlow controller (512
total entries minus the 14 entries reserved for internal
functionality)