Dspalm - Cisco MGX 8850 Command Reference Manual

Chapter 9 Troubleshooting Commands

dspalm

Display Alarm—displays the alarms from among the configured alarm types for a line.
Use the dspalm command to view the alarms associated with a specified line. See cnfalm for a
description of the types of alarms you can see. In addition to the configurable alarm types, the output
also shows instances of loss of cell delineation (LOCD).
Cards on Which This Command Runs
AXSM
AXSM Syntax
dspalm -ds3|-e3|-sonet|-ds1|-e1 <bay.Line>
Syntax Description
-ds3 | -e3 | -sonet
-ds1 | -e1
<bay>
<line>
Related Commands
cnfalm, clralm, dspalms, dspalmcnt
Attributes
Log: no log
Release 2.0, Part Number 78-10467-04 Rev C0, October 2001
Specifies a SONET line (OC-3c, OC-12c, OC-48c), DS3 line, E3
line. or DS1 line.
The bay (1 for upper or 2 for lower), and the line number. The line
number ranges from 1 to the highest number line on the back card.
Line number:
For OC12: 1
•
• For OC3: 1–4
• T3, E3: 1–8
State: active, standby Privilege: ANYUSER
Cisco MGX 8850 Routing Switch Command Reference
dspalm
9-51