Cisco MGX 8850 Command Reference Manual page 545

Routing switch

Hide thumbs Also See for Cisco MGX 8850:

Table of Contents

SPVC and SVC Commands

addcon <ifNum> <vpi> <vci> <service type> <mastership>

[-slave <NSAP.vpi.vci>]

[-lpcr <local PCR>]

[-rpcr <remote PCR>]

[-lscr <local SCR>]

[-rscr <remote SCR>]

[-lmbs <local MBS>]

[-rmbs <remote MBS>]

[-cdvt <local CDVT>]

[-lcdv <local maxCDV>]

[-rcdv <remote maxCDV>]

[-lctd <local maxCTD>]

[-rctd <remote maxCTD>]

[-cc <OAM CC Cnfg>]

[-stat <Stats Cnfg>]

[-frame <frame discard>]

[-mc <maximum cost>]

Syntax Description

For the applicable parameters, the "local" end is the point at which you are provisioning the connection.

Release 2.0, Part Number 78-10467-04 Rev C0, October 2001

The logical port number. The range for AXSM is 1–60. This ifNum corresponds

to the ifNum added through the addport command.

When adding an endpoint on a NNI port, make sure that PNNI signaling is

disabled on the PXM45 (cnfpnportsig <portid> -nniver none).

Virtual path identifier value in the range 0–255 (UNI) or 0–4095 (NNI or VNNI).

For VNNI, specify one VPI per port.

Virtual connection identifier (VCI):

For a VCC on a UNI, the range is 1–4095. On an NNI or VNNI, the VCI

range is 32–65535. For MPLS, the recommended minimum VCI is 35.

For a VPC, the vci is 0.

Cisco MGX 8850 Routing Switch Command Reference

Chapters

Table of Contents